roof

Building Maintenance Check List

building maintenance check list

A Proactive Approach is Best

If you are responsible for your condo or HOA’s physical condition, this is no time to relax. Planning now can pay big dividends in being able to hire a repair contractor before the spring/summer crunch arrives. With that in mind, the following list can provide a guide to issues for you to consider.

Building Maintenance Check list

  • Inspect the roofs.
    Too often, missing shingles and other storm related damage to roofs goes unnoticed during the winter. Now is the time for each roof surface to be scanned by eye, or better yet, by binoculars. Avoid going up on the roof unless it has a very low slope. Leave that to the pros. Other damage comes from removing ice dams and snow.  Snow removal can be the cause of more damage than the actual snowfall itself. Most buildings are designed to handle snow, and it is very rare that even a large storm will dump enough snow to cause damage that will seriously harm your homes’ roofs. Let the snow melt naturally with the rain and warmer temperatures.
  • Gutter, downspout, and roof drain repairs.
    Frozen gutters and downspouts can cause ice dams, but the most likely cause is building heat escaping due to poor insulation and/or inadequate venting of the air below the roof. Nonetheless, ensuring gutters run free to remove snow melt and spring rains is very important. Those condos with low-slope roofs and internal roof drains need to ensure those drains are clear of winter debris block water and causing surface ponding.
  • Ground surface drainage pathways.
    Clearing out your drains on a regular basis will ensure they are free of debris for the summer thunderstorms. April and May are notorious for high quantities of rain no matter where you live. For communities located in snowy areas of New England, the additional water from the snow runoff can equal a great stress on the community’s drainage system. Avoid the potential of blocked drainage systems by habitually cleaning them every other month. Subsurface drainage culverts need periodic cleaning to ensure the winter sanding operation and other debris runoff has not prevented the proper storm drainage.
  • If you have a basement, check your sump pump regularly to ensure its operation throughout the rainy season.
    The snow run off (or rain in warmer climates) can create an overload of moisture your sump pump may not be able to handle. Perform monthly inspections of the pump by opening the sump pit’s cover to clear any debris out of the bottom of the pit.
  • Replace snow stakes.
    It’s a common mistake to replace the snow stakes only once a year, usually at the beginning of winter. The stakes can be the first thing to be damaged after a heavy snowfall, particularly if the snowplow knocks it over!
  • Landscaping plans.  Landscaping can often take a hit during the cooler months. Recover quickly by bringing in your local specialist and discussing the various shrubs and flowers needing planting in spring.
  • Send out paint bids for summer work. The major advantage to getting your bid requests out early is the extra time and accessibility your vendors are likely to have. Outside work requests often drop during cold weather and getting a head start will ensure your association is at the top of their list during the summer rush!
  • Security enhancements. Now is the ideal time for associations to make the security enhancements they’ve been thinking about all winter. Security fencing and an alarm system are two timely projects for the post-winter months.
  • Equipment rechecks. Even if pre-winter checks have been done, halfway through the winter is a good idea to do it again. Test emergency generators, keep batteries fully charged, check outside light fixtures are operational, ensure outside utility meters and hydrants are accessible, confirm clearance for both outside vents and exhausts, and change quarterly air filters.

Of course, this list focuses mainly on operating issues. When was the last time you took a hard look at your Reserve Fund Plan for capital repairs? Is your condo on schedule? Have things changed? Does the Reserve Study need a major update? Perhaps it is time a for a building condition survey to be conducted. This top to bottom review can be performed in-house or by a professional building inspector engaged to provide an informed, unbiased assessment of the physical condition of the various common building and site elements including siding, roof surface, structural framing, foundation, water infiltration, electrical, plumbing, HVAC systems, flooring, light fixtures, paving, and more. Providing a questionnaire to the unit owners during this process not only engages them in this important work but also may reveal common defects not readily known

Many maintenance projects have a double bonus—they will improve the appearance of your association while preventing costly repairs or replacements down the road. By undertaking some maintenance tasks now, you can lessen the costs many associations rack up in the rush to recover from winter.

Building Maintenance Check List – Article written by Jack Carr, P.E., R.S., LEED-AP, Criterium Engineers
Published in Condo Media
Download a PDF Version of this Condo Media article

Read more

Why Plan a New Roof Now?

why plan a new roof now 2

Analyze Cost and Replacement Options

When was the last time you hired a contractor? When was the last time you checked construction material costs? You are in for a shock. With a shortage in skilled workers, supply chain uncertainty, and inflationary pressure on petroleum products (shingles, underlayment, etc.), just finding a contractor willing to commit to a schedule or budget will be a challenge.

Whether your community has a single roof or multiple buildings, your annual inspection by a qualified roofing consultant or engineer should provide a reasonably accurate roof surface replacement schedule. Often, a roof surface is one of the most expensive components in a building to replace. This makes the decision to resurface a roof a difficult one for building owners and managers. The temptation is to postpone the inevitable for one more year. A roof can be nursed along year after year, but this is likely to prove to be a false economy.

In the long term, it makes economic sense to replace a roof surface earlier rather than later. If the life of a roof is extended much beyond its useful life, maintenance costs are likely to increase beyond prorated replacement costs. There is also the danger water penetration (some of which may not be visible) will cause damage to the underlying structure or other building components. The reduction in insulation value of wet insulation and the resulting increases in heating and cooling costs are other factors that contribute to making roof replacement a good economic decision. Finally, the liability of a major failure must be considered.

Thus, roof problems are among the most frequent areas of concerns for condo associations. Here are a few helpful thoughts about roofs for your association:

Surface materials have been improved.

  • Shingles:  These consist of a composite base (asphalt, fiberglass, etc.) and sand wearing surface. They are relatively easy to install and moderately priced. The thickness (weight) generally defines the likely service life. In other words, a thicker shingle will last longer. The weight is given as pounds per square (100 square feet equals one square).
  • Membrane roofs: These have become the primary way to cover flat roofs within the last 20 years. Membrane roofs are typically somewhat more expensive than the other alternatives for flat roofs. However, they generally last longer and have fewer maintenance problems.
  • Metal roofs:  Metal roofs are becoming more common in northern New England. There are a variety of reasonably good products on the market. Metal roofs are used on sloped surfaces. A successful metal roof is very dependent on good workmanship. Unskilled hands installing a metal roof will almost always lead to problems.

Flashing is at least as important as the surface.

The roof is a system that includes the sheathing, underlayment, flashing, and the roof surfacing. If you are having problems with your roof, it is important to understand there are several different components involved.

The roof flashing is as often the cause of leaks as the roof surfacing. Repairing flashing requires skill. Caulking flashing leaks is not adequate. If there is a flashing problem, the only effective repair usually requires installing new flashing. That work, to be successful, must be done by someone specifically trained and experienced with flashing work.

Workmanship makes the difference.

Roof problems are more frequently the result of poor workmanship than material deficiencies. While there have been some defective roof materials, our experience inspecting thousands of buildings in New England has shown us that workmanship is more commonly the problem. When you select a roofer, you should check their references.

Five steps to a better installation.

  1. When you evaluate your existing roof, make sure you have an independent consultant. If you ask a roofer to evaluate your roof, it is very likely the conclusion will be the roof needs to be replaced very soon.
  2. When you decide to install a new roof, you should prepare a detailed set of construction documents. The documents should:
    • Define exactly how you expect things to be done, what is the scope of the project, what materials are to be used, and what is the intended schedule for completion.
    • Be very specific about the materials to be used.
    • Be very specific about how waste material is to be handled.
  3. Retain the services of a consultant to prepare the construction documents and to monitor the work while it is underway. As an association, you need someone knowledgeable about the construction industry who does not have any direct interest in your project other than serving your best interests.
  4. You should choose time proven materials. You should not experiment with untested products and/or installation techniques.
  5. You should make sure there is a three-to-five-year guarantee against problems with both material deficiencies and workmanship backed with a bond.

Roofs are expensive and disruptive to install. Diagnosing problems objectively is difficult. You should always work with a good, independent consulting engineer or roofing consultant. That person can help evaluate problems, prepare construction documents for repair or replacement, and monitor the work to be sure it is done well. Using a consultant also means that the officers of the association are less vulnerable to liability from the owners.

Article written by Jack Carr, P.E., R.S., LEED-AP, Criterium Engineers
Published in Condo Media

Read more